Indy
Misfit
- User ID
- 57
Hey, All. It's been a while. 
Just been rootin' around in between jobs and came up with a bloke's version of a incense holder, made out of 25mm box and 50mm right angle Duragal off cuts. I had been looking around online for a decent one, but any that appealed to me were starting around the 50 buck mark. Hence why this fucker come about..
The pincer tongs that holds the incense stick have been welded to be spring loaded so as to hold the stick, only prob I got a bit carried away there and I need to part the tongs with a screw driver to remove/replace the sticks. That, and the fact I made the fucker 50mm shorter than what I anticipated to be needed for the sticks are about the only two fuck ups I would try and improve on next time round if I ever went there again.
Also, last pic shows a platform for the cone shaped incense to sit on. That's it for another dodgy project.
Just been rootin' around in between jobs and came up with a bloke's version of a incense holder, made out of 25mm box and 50mm right angle Duragal off cuts. I had been looking around online for a decent one, but any that appealed to me were starting around the 50 buck mark. Hence why this fucker come about..
The pincer tongs that holds the incense stick have been welded to be spring loaded so as to hold the stick, only prob I got a bit carried away there and I need to part the tongs with a screw driver to remove/replace the sticks. That, and the fact I made the fucker 50mm shorter than what I anticipated to be needed for the sticks are about the only two fuck ups I would try and improve on next time round if I ever went there again.
Also, last pic shows a platform for the cone shaped incense to sit on. That's it for another dodgy project.
