Incense holder

Indy

Misfit
User ID
57
Hey, All. It's been a while. :oops:

Just been rootin' around in between jobs and came up with a bloke's version of a incense holder, made out of 25mm box and 50mm right angle Duragal off cuts. I had been looking around online for a decent one, but any that appealed to me were starting around the 50 buck mark. Hence why this fucker come about..

20210714_123850.jpg 20210714_123739.jpg 20210714_123244.jpg

The pincer tongs that holds the incense stick have been welded to be spring loaded so as to hold the stick, only prob I got a bit carried away there and I need to part the tongs with a screw driver to remove/replace the sticks. That, and the fact I made the fucker 50mm shorter than what I anticipated to be needed for the sticks are about the only two fuck ups I would try and improve on next time round if I ever went there again.

Also, last pic shows a platform for the cone shaped incense to sit on. That's it for another dodgy project. šŸ˜œ
 

Please join our community to continue reading

Forgot your password?
Don't have an account? Register now
Top Bottom